Frequently clean the powder coating gun can maintain and extend the useful life of equipment. Powder slag often adhere to In the the the the moist or humid of of the within the the climate gun of, to reduce the effective the service life of. The powder coatings is a kind of dry expected, the and in the the leave residues in the the gun, but this is very easy to cleaning.
The following are specific clean detailed descriptions: 1 Prepare the powder spray gun, the cleaning area. Lay a tarp under the gun to flee, so that the powder residue will not spread and stained. 2 Gun powder coatings. Discharge gun voltage remaining. Touch launch to the ground clip to fulfill the powder coating gun. 3 Loosen the cap room cup with flour, pour the remaining powder in the powder container. The discharge of compressed air spray clean the outside of the pickup tube, deflector plates, cups and static tubes. Use no more than 30 pounds of compressed air. 4 Twist off the deflector, and remove the three static tube. Cleaning the tube inside and outside - the diversion - with the air compressor. The air compressor is usually cleaning the pollen tube, but you can also use an engine cleaning brush. 5 The the the air clean in the the inside the glass tubes are directly spraying of within the the in the pickup tube. Re-install the deflector and the static tube. Stored in a dry place, moisture-proof powder coating gun.